How To Lay Vinyl Plank Flooring Around A Toilet

How to Lay Vinyl Plank Flooring Around a Toilet Base

Installing vinyl plank flooring is a popular home improvement project as it's a relatively affordable, easy-to-install option that mimics the look of hardwood floors. However, when it comes to laying vinyl plank flooring around a toilet base, there are a few specific steps you need to take to ensure a professional-looking and waterproof finish. ### Planning and Preparation -

Gather your tools:

You'll need a utility knife, measuring tape, chalk line or pencil, spacers, hammer, and a toilet flange adapter or toilet flange ring. -

Measure and mark:

Determine the distance from the wall to the center of the toilet flange. Mark this measurement on the vinyl plank flooring and cut it to size using a utility knife. -

Install the toilet flange adapter:

Place the toilet flange adapter over the toilet flange and secure it with screws. This will create a raised surface for the vinyl plank flooring to fit around. ### Cutting and Installing the Flooring -

Cut around the toilet base:

Place the measured and cut vinyl plank flooring against the toilet base and trace the outline of the base onto the flooring. CAREFULLY cut along the traced line using a utility knife. -

Create an "L" cut:

Once you have cut the outline, make an "L" cut at each corner of the toilet base to allow the flooring to fit snugly around it. -

Install the flooring:

Slide the cut vinyl plank flooring piece under the toilet base and tap it into place using a hammer and spacers. Ensure that the flooring is level and flush with the surrounding planks. ### Finishing Touches -

Trim excess flooring:

Once the vinyl plank flooring is installed, use a utility knife to trim any excess flooring that extends beyond the toilet base. -

Seal around the toilet:

Apply a bead of silicone caulk around the perimeter of the toilet base where it meets the vinyl plank flooring. This will prevent water from seeping through and damaging the flooring. -

Reinstall the toilet:

Carefully lift the toilet and place it back on the toilet flange adapter. Secure the toilet with bolts and reconnect the water supply and drain line. ### Additional Tips -

Use a sharp utility knife:

A dull knife will make it more difficult to cut the vinyl plank flooring cleanly. -

Measure twice, cut once:

Double-check your measurements before cutting the flooring to avoid mistakes. -

Take your time:

Installing vinyl plank flooring around a toilet base requires patience and precision. Don't rush the process to ensure a professional-looking finish. -

If you're not confident:

Don't hesitate to hire a professional flooring installer to ensure the job is done correctly. By following these steps and tips, you can successfully lay vinyl plank flooring around a toilet base, creating a seamless and waterproof floor that will enhance the look of your bathroom.