How To Lay Vinyl Floor Tiles Around A Toilet

Installing vinyl floor tiles around a toilet requires precise measurements, careful cutting, and proper adhesive application. By following these steps, you can achieve a professional-looking and durable floor covering.

Materials and Tools:

Vinyl floor tiles
Measuring tape
Pencil or marking tool
Utility knife
Adhesive
Spreader
Grout or caulk (optional)

Step 1: Preparation

Clean and dry the subfloor thoroughly. Remove any debris or dust that may interfere with the adhesion of the tiles. Measure the area around the toilet and cut the tiles to size, leaving a small gap between them for expansion.

Step 2: Measure and Cut the Toilet Flange

Locate the toilet flange, which is the metal base that connects the toilet to the drainpipe. Measure the distance from the wall to the center of the flange. Transfer this measurement to the vinyl tile and mark the center point. Using a utility knife, carefully cut a circle or square around the marked point, ensuring that the hole is slightly smaller than the flange.

Step 3: Apply Adhesive

Spread a thin layer of adhesive around the flange hole and onto the subfloor where the vinyl tile will be placed. Use a spreader to ensure even coverage and remove any excess adhesive.

Step 4: Install the Tile

Carefully align the vinyl tile with the flange hole and press it firmly into place. Use a rubber mallet or rolling pin to apply pressure and ensure good adhesion. Trim any excess tile around the edges.

Step 5: Secure the Toilet

Reinstall the toilet carefully and reconnect the water supply and drain line. Ensure that the toilet is level and secure before using it.

Step 6: Grout or Caulk (Optional)

For a more finished look, you can apply grout or caulk around the edges of the vinyl tile and the toilet base. This will help seal the joints and prevent moisture from seeping in.