Installing Lifeproof Flooring On Concrete

Installing Lifeproof Flooring on Concrete: A Step-by-Step Guide

Installing Lifeproof flooring on concrete is a relatively straightforward process that can be completed in a few hours. However, there are a few essential steps that must be followed to ensure a successful installation.

1. Prepare the Subfloor

The first step is to prepare the subfloor. The concrete must be clean, level, and dry. Any cracks or holes should be repaired with a concrete patch.

2. Install the Underlayment

Once the subfloor is prepared, the next step is to install the underlayment. The underlayment will help to absorb sound and provide a cushion for the flooring.

3. Lay Out the Flooring

Once the underlayment is installed, the next step is to lay out the flooring. Start in the center of the room and work your way out. Make sure to leave a gap of about 1/4 inch around the edges of the room for expansion.

4. Lock the Planks Together

Once the flooring is laid out, the next step is to lock the planks together. Start by aligning the end of one plank with the side of another plank. Then, simply push down on the end of the plank until it locks into place.

5. Trim the Excess

Once the flooring is installed, the next step is to trim the excess. Use a sharp utility knife to score the flooring along the edges of the room. Then, simply snap the excess off.